ISR Performance Hydraulic Hand Brake L-Shaped V2

The ISR Performance hydraulic hand brake L-shaped V2 is a vertical hydraulic handbrake with an inline master cylinder, built for drift and rally cars that need instant, repeatable rear lockup. The V2 handle is 1.5 inches thick at the top and tapers to 1.2 inches at the bottom, giving a solid grip at the top of the pull with a slimmer profile where it meets the base. Overall it stands 18.5 inches tall and measures 10 inches long with the master cylinder fitted.

Specifications

• L-shaped vertical handle, V2 design
• Handle thickness: 1.5 inches at the top, tapering to 1.2 inches at the bottom
• Height: 18.5 inches
• Length including master cylinder: 10 inches
• Inline master cylinder included

Why Hydraulic

A cable handbrake was never meant for repeated full-force pulls at speed. A hydraulic handbrake plumbed inline with the rear brake circuit locks the rears with far less effort and releases cleanly the instant you let go, which is what initiation and transitions in drift, and handbrake turns in rally, depend on.

Recommended Fittings for the Master Cylinder

• 1x banjo bolt, 11x1.25mm x 15/16 inch
• 1x 7/16 banjo fitting to -3AN
• 2x 7/16 inch crush washers
• 1x master cylinder to brake line adapter, 3/16 tube to 3/8 inch-24 flare female, -3AN male
• 1x #3 x 3/8-24 inverted flare brake adapter, steel

What's in the Box

• 1x V2 L-shaped hand brake
• 1x inline master cylinder

Install Notes

Fittings and brake line are not included; the list above covers what is recommended to plumb the master. Mount the base to a reinforced section of the floor or tunnel, plumb it inline on the rear circuit, and bleed thoroughly before the first run.

All ISR Performance products are designed for off-road use only.