ISR Performance Hydraulic Hand Brake - L-Shapped

The ISR Performance hydraulic hand brake in the L-shaped configuration is a vertical pull hydraulic handbrake for drift, rally and track cars. The L-shaped layout puts the handle upright beside the driver, where it falls to hand without reaching down to the tunnel, and the hydraulic master cylinder gives consistent rear lockup pull after pull where a stock cable brake would stretch and fade.

Highlights

• L-shaped vertical handle design
• Hydraulic actuation via a master cylinder
• Universal mounting for drift, rally and time attack builds

Original L-Shaped Design

This is ISR's original L-shaped hydraulic handbrake. The later V2 version adds a thicker tapered handle; this model is the standard handle for drivers who prefer the original feel or want to match an existing setup.

Recommended Fittings for the Master Cylinder

• 1x banjo bolt, 11x1.25mm x 15/16 inch
• 1x 7/16 banjo fitting to -3AN
• 2x 7/16 inch crush washers
• 1x master cylinder to brake line adapter, 3/16 tube to 3/8 inch-24 flare female, -3AN male
• 1x #3 x 3/8-24 inverted flare brake adapter, steel

Install Notes

The fittings above are recommendations and are not included. Bolt the handbrake base through a reinforced floor section or a fabricated bracket, plumb the master cylinder inline with the rear brake circuit, and bleed the system completely. A handbrake that is plumbed inline will also apply the rear calipers with the pedal as normal.

All ISR Performance products are designed for off-road use only.