ISR Performance Hydraulic E-Brake -3an fitting Kit

Plumbing a hydraulic handbrake with a pass through master cylinder usually means stacking adapters to get from the standard brake fitting size out to AN hose. The ISR Performance hydraulic e-brake -3AN fitting kit cuts that down to the exact pieces you need to convert the master's ports to -3AN, so the hard line and braided hose connect without extra fittings in the chain.

Kit Contents

• 1x Banjo bolt, M11x1.25
• 1x Banjo fitting, 7/16 (11mm) to -3AN
• 2x 7/16 inch crush washers
• 1x ISR Performance -3AN e-brake fitting

What It Does

• Converts a pass through hydraulic e-brake master from the standard brake fitting size to -3AN
• Removes the need for separate adapters at the master cylinder
• Gives you a banjo style connection on one side and a direct -3AN fitting on the other

Important

The master cylinder is not included. This is the fitting kit only, meant to work with an ISR hydraulic e-brake or another pass through master that uses the same port specification.

Install Notes

Always use new crush washers on both sides of the banjo fitting, and torque the banjo bolt to spec rather than guessing. Bleed the handbrake circuit thoroughly after assembly. On a drift car the hydro line sees a lot of vibration, so route the -3AN hose with gentle bends and support it so the fittings are not carrying the load.

All ISR Performance products are designed for off-road use only.