ISR Performance High Tensile Strength Offset Steering Rack Spacers

Steering bind is one of the first problems a 240SX owner hits after installing aftermarket knuckles: as the rack travels to lock, the geometry runs out of room and the steering gets heavy or hangs up. The ISR Performance high tensile strength offset steering rack spacers are a simple fix for that bind on the Nissan 240SX.

The problem they solve

With aftermarket knuckles the bind problem is more common, because the knuckle changes the relationship between the inner tie rod pivot and the lower control arm. Normally the cure is to relocate the entire steering rack to open up the geometry and gain access to more steering lock. That is a fabrication job. With ISR's offset rack spacers the same problem is solved by moving the rack with bolt-on spacers instead.

Features

• Offset design shifts the rack mounting position to relieve bind
• High tensile strength construction to carry steering loads reliably
• Lets the steering reach more usable lock with angle-kit knuckles
• Avoids cutting or welding to relocate the rack

Fits

• Nissan 240SX (S-chassis)

Install notes

Moving the rack changes tie rod angle, so check bump steer and toe after install and confirm the tie rods clear the frame rails and crossmember at full lock. Pair the spacers with ISR's inner tie rods and tie rod ends for the 240SX for a complete steering setup built around increased angle.

All ISR Performance products are designed for off-road use only.