ISR Performance Driveshaft – RB Swap S14 ABS – Steel

For the ABS-equipped Nissan 240SX S14 running an RB engine swap, this ISR Performance steel driveshaft is the direct-fit driveline solution. It is manufactured to the length set by the ISR RB swap mounts and finished with the ABS differential flange pattern used on those 1995 to 1998 cars.

Steel for the long haul

A steel driveshaft is the durable, economical choice. It handles the torque of an RB without fuss, resists damage better than aluminum and keeps the swap budget in check. Builders who prioritize weight savings may prefer aluminum, but for most street and drift S14s steel is the practical pick.

• Steel construction
• Built for the RB swap position in the S14
• ABS differential flange pattern

Application

Nissan 240SX S14, 1995 to 1998, RB engine swap, factory ABS rear differential. Non-ABS S14 chassis take the non-ABS version.

Before installing

Confirm the ABS flange on your differential. Install with the suspension loaded to check driveline angles, verify clearance to the tunnel and exhaust, and torque the flange hardware to spec. Recheck the bolts after the first drive.

All ISR Performance products are designed for off-road use only.