J Replace Reinforced OE Style Replacement Engine and Transmission Mount Kit - Nissan 240sx 89-98

The J Replace reinforced OE style engine and transmission mount kit for the 1989 to 1998 Nissan 240SX tightens up the whole drivetrain in one install. The mounts are 30% stiffer than standard rubber, which cuts the engine rock that causes shift jerk and lazy throttle pickup, while keeping an OE style design that bolts in without adapters.

What Stiffer Mounts Do

• 30% stiffer than standard mounts for improved drivetrain stability
• Reduces jerking during gear changes
• Delivers a tighter, more immediate throttle response
• Keeps the engine and transmission located under hard driving

Compatibility

Fits all 1989 to 1998 Nissan 240SX models, S13 and S14, with the KA24E, KA24DE or SR20DET engine. Because the SR20DET uses the same mount locations in these chassis, this kit is a popular pick when doing an SR swap and the original rubber is already tired.

Who Needs This Kit

Anyone performing a motor swap, chasing driveline slop on a drift or track car, or simply replacing sagging factory mounts that have let the engine drop will benefit. Stiffer mounts transmit a bit more vibration into the cabin than soft stock rubber, which most enthusiasts accept in exchange for the sharper response.

Installation

Support the engine and transmission from below, remove the old mounts one at a time and swap in the reinforced units. Check that no lines, wiring or the transmission crossmember are under strain before final torque.

Note: Legal only for use in competition vehicles, which may never be registered, licensed, and/or used on public streets or highways, and also for use in other exempted vehicles.