J Replace OE Replacement Clutch Pedal Assembly - Nissan 240sx 89-98 S13 S14

Worn clutch pedal bushings, a cracked bracket or a stripped pivot are common on thirty year old 240SX chassis, and a loose pedal makes clean shifting a chore. The J Replace OE replacement clutch pedal assembly covers the 1989 to 1998 Nissan 240SX, both S13 and S14, with a complete new assembly so you are not rebuilding a tired original.

Highlights

• Complete OE replacement pedal assembly for S13 and S14 240SX
• Supplied in S14 configuration
• Solves pedal play, squeaks and uneven clutch engagement from worn pivots
• An alternative to increasingly scarce and expensive OEM parts

Fitment

1989 to 1998 Nissan 240SX, S13 and S14 chassis, manual transmission.

S13 Installation Requirement

The pedal is built in the S14 layout. To install it in an S13, you must drill out and remove the spacer from the pedal bracket. Plan on this step before you begin the job, and make sure you understand the modification before ordering for an S13.

Install Notes

Disconnect the clutch master cylinder pushrod and the pedal return spring, unbolt the bracket from the firewall and dash support, then transfer the clutch switch if your car has one. Lubricate the pivot and adjust the pedal height and free play to spec once the new assembly is in place. Pairing this with a new clutch master cylinder is a good idea if the original is showing its age.

Verify compatibility with your specific vehicle before purchase.