ISR Performance Wheel Spacers - 4/5x100 Bolt Pattern - 56.1mm Bore - 5mm Thick (Individual)

The ISR Performance 5mm wheel spacer is a slip-on spacer for 4x100 and 5x100 bolt patterns with a 56.1mm center bore, sold as a single piece. Five millimeters is the increment that tames a wheel that sits just a bit too far inboard or rubs the inside of a coilover, pushing the wheel out without changing offset through a new set of wheels.

Specifications

• Thickness: 5mm
• Bolt pattern: 4x100 and 5x100 (dual drilled)
• Hub bore: 56.1mm
• Sold individually, one spacer per purchase

Compatibility

Hubs with a 4x100 or 5x100 bolt pattern and a 56.1mm hub diameter. The 5x100 pattern with 56.1mm bore is common on Subaru models, and 4x100 with the same bore appears on a number of compact chassis. Verify your hub bore and pattern before ordering, since a spacer that does not match the hub bore will not center the wheel properly.

Ordering

Because each spacer is sold individually, order two for one axle or four for the whole car.

Fitment Notes

A 5mm slip-on spacer uses your existing studs, so confirm you still have adequate thread engagement on the lug nuts after installing it. Make sure the hub face and spacer are clean and flat, torque the wheels to spec, and re-check torque after driving. If you need to push the wheel out more than a slip-on spacer allows, a bolt-on spacer with its own studs is the safer route.

All ISR Performance products are designed for off-road use only.