ISR Performance Driveshaft – RB Swap S13 ABS – Aluminum

This ISR Performance aluminum driveshaft is for the S13 240SX that has both an RB engine swap and a factory ABS rear differential. ABS S13 rear ends use their own differential flange, so a non-ABS shaft will not bolt up, and this version is built with the correct ABS pattern from the start.

Why go aluminum on an RB swap

RB engines and their gearboxes already add weight over the original four cylinder. An aluminum driveshaft gives some of that back, reducing both static weight and the rotating mass the engine has to accelerate. For a street or drift car that sees high rpm, that is a worthwhile trade.

• Aluminum tube
• Sized for the ISR RB swap mount position in the S13
• ABS differential flange pattern

Application

Nissan 240SX S13, RB engine swap, ABS-equipped rear differential. For non-ABS cars, choose the non-ABS version instead.

Fitting notes

Look at your differential flange and confirm ABS fitment before ordering. Install at ride height, check driveline angles and clearance to the tunnel and exhaust, and use proper torque on the flange hardware. Keep the aluminum tube free of dings to preserve balance.

All ISR Performance products are designed for off-road use only.