ISR Performance Driveshaft - KA/SR S13 Non ABS - Steel

The ISR Performance steel one-piece driveshaft for the S13 240SX replaces the factory two-piece shaft and its rubber carrier bearing on KA24DE and SR20DET cars with a 5-speed manual and a non-ABS differential. Removing the carrier bearing takes a source of slop out of the driveline, so throttle input reaches the rear tires with less delay and less movement under hard acceleration.

Construction

• One-piece steel driveshaft conversion
• Dana/Spicer solid high-performance U-joints
• Direct replacement for the OEM two-piece unit; the factory carrier bearing is no longer used

Application

• Nissan 240SX S13
• KA24DE or SR20DET
• 5-speed manual transmission
• Non-ABS differential

Check your differential before ordering

ABS and non-ABS S13s use different driveshaft lengths. Even if your car left the factory with ABS, a previous owner may have swapped the differential, so verify what is actually in the car rather than going by the build sheet. If you find an ABS differential, you need the ABS version of this driveshaft instead.

Lead time

Each driveshaft is built to order with roughly a one-week lead time before it ships. Once installed, the carrier bearing bracket is left out, which also removes a wear item that is a frequent source of vibration on high-mileage S13s.

All ISR Performance products are designed for off-road use only.