ISR Performance Top Mount Turbo Lines - SR20DET S13 Motor

Moving to a top mount manifold on an S13 SR20DET means the stock turbo hard lines no longer reach, and bending or splicing them is not a solution. The ISR Performance top mount turbo line kit for the S13 SR20DET is the extended-length version of the ISR braided line set, built to feed oil and coolant to a top mounted turbo with the same quality fittings and hose used across the range.

Specification

• Replaces the factory hard lines found on S13, S14 and S15 SR20DET T25/T28 turbos, here in the top mount configuration for the S13.
• Pre-dyed black Nomex covered racing hose for a consistent, fade-resistant appearance.
• Kevlar reinforcement in the fire-retardant Nomex cover improves abrasion resistance and hose strength.
• Smooth, firm inner tube of black nylon reinforced synthetic rubber with a lightweight outer fibre cloth braid.
• Up to 45 percent lighter than conventional high performance racing assemblies.
• High quality aircraft fittings and a fresh set of aluminum washers included.

Fits

Nissan S13 SR20DET with a top mounted turbo. If your turbo is still in the factory bottom mount position, choose the S13 bottom mount kit instead.

Routing Advice

With a top mount turbo the lines pass close to the manifold, so take advantage of the heat-resistant Nomex cover but still route away from direct contact with the runners. Use the supplied aluminum washers, torque the banjos evenly, and the result is a leak-free, clean looking top mount install.

All ISR Performance products are designed for off-road use only.