ISR Performance Stainless Steel Rear Brake Lines - Nissan 240sx - 300zx Z32 Conversion

Finishing a 300ZX rear brake conversion on a 240SX means the rear hoses need to change along with the calipers. The ISR Performance stainless steel rear brake lines for the Nissan 240SX Z32 conversion are made for exactly that pairing, so the rear Z32 calipers connect cleanly to the S13 or S14 hard lines without a parts-bin workaround.

Construction

Each line uses an inner hose wrapped in a braided stainless steel outer. The braid stops the hose from ballooning when you lean on the pedal, which is the main reason rubber hoses feel soft and vague after years of heat cycles. With the rear end on Z32 calipers and these lines, the rear of the brake system responds to pedal input with much less lag.

Fits

• Nissan 240SX, S13 and S14 chassis
• Rear Z32 300ZX brake conversion
• Rear lines only; pair with the ISR front Z32 conversion lines for a complete set

Before you install

Professional installation is recommended. Note where any C-clips and brackets sit before removing the old hoses, use new crush washers, and keep the hoses from twisting as you tighten the ends. Once everything is torqued, bleed with fresh DOT brake fluid and inspect for leaks before driving. Mixing rubber and stainless hoses on the same car is not recommended, so plan on doing the fronts as well.

All ISR Performance products are designed for off-road use only.