ISR Performance Stainless Steel Rear Brake Lines - Nissan 240sx S13/S14

The rear hoses on a 240SX get ignored because they are tucked out of sight, but they are just as old as the fronts and just as prone to expansion. The ISR Performance stainless steel rear brake lines for the Nissan 240SX S13 and S14 bring the rear of the hydraulic system up to the same standard as a braided front set.

Design

A braided stainless steel outer wraps the inner hose and keeps it dimensionally stable when the system is pressurized. On a car that sees handbrake entries and hard trail braking, that stability translates into a pedal that feels the same at the end of a session as it did at the start.

Fitment

• Nissan 240SX S13, 1989 to 1994
• Nissan 240SX S14, 1995 to 1998
• Factory rear brake calipers (not for Z32 rear conversions)
• Rear lines only

Fitting tips

Have a professional handle installation. Fresh crush washers go at every banjo, and the hose should follow the original routing without being rotated, stretched or forced into position. Tighten fittings last, after you have verified clearance through full suspension travel, then bleed with new DOT fluid and check every joint for seepage. Run the matching ISR front S13/S14 set at the same time so the whole system uses stainless lines.

All ISR Performance products are designed for off-road use only.