ISR Performance S13 SR20DET RWD Cold Pipe

The ISR Performance S13 SR20DET RWD cold pipe is the single cold side charge pipe that runs from the intercooler outlet to the factory intake manifold throttle body on an S13 with the rear wheel drive SR20DET. It is made for the stock intake manifold, so the throttle body end lines up with the factory throttle body position without adapters.

Details

• Cold side pipe for the S13 SR20DET, rear wheel drive layout
• Routes to the stock intake manifold throttle body
• Sold as a single pipe, separate from the full ISR piping kit

When You Need This

Cold pipes take the most abuse on an S-chassis because they sit low and forward near the radiator support and bumper. A minor front end tap, a loose clamp that lets the pipe rub through, or a prior owner's hack job are all good reasons to swap in a fresh piece. It is also the pipe to grab if you built a kit around a different core and need a proven throttle body side solution.

Fitment

Nissan 240SX S13 with the SR20DET RWD engine using the factory intake manifold. If you run an aftermarket intake manifold with a relocated throttle body, see the ISR intake manifold cold pipe instead.

Install Notes

Confirm the coupler diameter at each end before ordering clamps and couplers. Check clearance to the power steering lines and the lower radiator hose during mock-up.

All ISR Performance products are designed for off-road use only.