ISR Performance Hose End Fitting - 10AN 90 Degree

The ISR Performance -10AN 90 Degree Hose End Fitting is the right-angle end for large-bore lines. On many turbo installs, the oil drain fitting points at the block or a crossmember, and a -10AN line cannot bend sharply enough to clear without this fitting doing the work. It is lightweight, black anodized, and from the same fitting family ISR has run on their turbo line kits for over five years.

Specifications

• Size: -10AN
• Angle: 90 degrees
• Black anodized finish
• Lightweight universal hose end
• Priced per single hose end

Applications

Turbo oil drains are the first use, followed by oil cooler lines where the cooler mounts behind the bumper and the ports face sideways, and remote oil filter relocation kits. In each case the 90 degree end turns the line immediately so the hose can run with a wide radius and no restriction.

A word on drains

A turbo drain relies on gravity, so route the -10AN line with a continuous downhill fall to the pan, avoid sharp bends, and make sure the pan fitting enters above the oil level. The 90 degree end at the turbo is what makes a clean downhill run possible in a tight bay.

Pairs with

ISR -10AN black nylon hose by the foot, plus ISR -10AN straight and 45 degree ends.

All ISR Performance products are designed for off-road use only.