ISR Performance Front Mount Intercooler Piping Kit - Nissan 240sx 2JZ Swap

Fitting a 2JZ with its factory twin turbos into an S13 or S14 240SX leaves you with the problem of routing charge piping to a front mount intercooler around the stock intake manifold. The ISR Performance front mount intercooler piping kit for 2JZ swapped S-chassis solves that with pre-bent pipes designed to connect the existing ISR front mount intercooler core (IS-S13ICCore) to a 2JZ running the factory turbos and factory intake manifold, mounted on ISR Performance swap mounts.

Designed around a specific setup

This is not a universal pipe kit. The routing assumes the following combination:

• Nissan 240SX S13 or S14 chassis
• Toyota 2JZ with stock twin turbos
• Factory 2JZ intake manifold
• ISR Performance 2JZ swap mounts
• ISR Performance front mount intercooler core, part IS-S13ICCore

If your swap uses a single turbo conversion or an aftermarket intake manifold, the pipe lengths and angles will not line up, so confirm your parts list before ordering.

What's in the box

• 4x intercooler pipes
• 6x intercooler couplers
• 12x T-bolt clamps

Install considerations

Couplers and clamps are supplied for every joint, so the kit can be assembled without sourcing extra hardware. Test fit the pipes with the clamps loose, check clearance to the radiator, fans and bumper support, then tighten everything once the routing is confirmed.

Note: this kit will not work with a 1JZ.

All ISR Performance products are designed for off-road use only.