ISR Performance Driveshaft - RB20 Swap S13 ABS - Aluminum

If your 1989-1994 Nissan 240SX S13 came with ABS, the rear differential uses a different flange than the non-ABS car, and your RB20 swap driveshaft needs to match it. This ISR Performance aluminum driveshaft is built specifically for an RB20DET swap using the RB20 transmission in an ABS equipped S13, with both the length and the rear flange correct for that combination.

Why Go Aluminum

Compared with a steel shaft, aluminum drops a noticeable amount of rotating weight from the driveline. Less mass to spin means the RB20 revs more freely, the throttle feels sharper, and the transmission and differential see less shock load during gear changes and clutch kicks.

Build Details

• One piece aluminum driveshaft, dynamically balanced for smooth operation at speed
• High quality universal joints at both ends
• Direct bolt-in when used with the matching ISR RB20 swap mounts, no cutting or shimming required

Fits

• 1989-1994 Nissan 240SX S13 with ABS
• RB20DET engine, RB20 transmission

Before You Order

Double check that your car actually has ABS, since a non-ABS S13 takes a different shaft. Match the engine, the transmission and the ABS status to this listing. If you are unsure which driveshaft you need, reach out before ordering and we will confirm the right part for your swap.

All ISR Performance products are designed for off-road use only.