ISR Performance Race Exhaust - Mazda Miata ND 16+

The ISR Performance race exhaust for the 2016 and up Mazda ND Miata is a straight through, mufflerless system built to be the lightest possible exhaust for a track driven ND. The mid pipe is a two piece design in 2.5 inch stainless steel, flowing into a rear muffler delete section that steps from 2.75 to 3 inches. There is no muffler, no resonator and no packing to burn out, just stainless pipe from the front flange to the tip.

Specs

• 2.5 inch stainless steel mid section, two piece
• 2.75 inch to 3 inch rear muffler delete section
• V-band joint between sections
• Gasket, hardware and V-band clamp included

What to expect

Shedding the factory muffler takes a significant amount of weight off the rear of the car and opens up the exhaust note considerably. This is a loud, race oriented setup and is intended for track use rather than quiet street driving. ISR has a video showing how the exhaust looks and sounds installed on an ND.

Fitment

2016 and newer Mazda MX-5 Miata ND. This exhaust has not been tested on the ND Club models and may interfere with the Club bumper cover.

What's in the box

• 1x race muffler delete pipe
• 1x mid pipe
• 1x V-band flange
• 1x 2.75 inch exhaust gasket
• 2x bolts
• 2x nuts

Install

Swap out the stock unit from the mid pipe back, use the supplied gasket at the front flange and the V-band clamp between sections, and check for clearance to the rear bumper before final tightening.

All ISR Performance products are designed for off-road use only.