ISR Performance Pro Series Rear Toe Control Rods - Nissan 240sx 89-98 S13/S14

Rear toe is the alignment setting that most directly decides how a 240SX behaves on corner entry, and the factory toe rods were never built for adjustment or for the loads a drift or track car puts through them. The ISR Performance Pro Series rear toe control rods give the 1989-1998 Nissan 240SX S13 and S14 a rigid, adjustable toe link developed from ISR's long-running Street Series arms.

Built beyond the Street Series

ISR released the Pro Series as a higher end line after years of success with the basic arms. The improvements over the Street Series are concrete:

• Japanese spherical rod bearings in place of softer pivots
• Larger rod ends for higher load capacity
• Dust boots on each rod end to extend bearing life
• Thicker materials in the rod body
• Added bracing for stiffness under side load

Proven in competition

These are the same toe rods used on Patrick Goodin's professional Formula Drift race car, where they handle the abuse of 1000+hp. If they survive that program, they will hold alignment on a weekend track car without complaint.

Compatibility

• Nissan 240SX S13, 1989-1994
• Nissan 240SX S14, 1995-1998

Setup notes

These rods are intended for street and track use. Set toe with the car at ride height and loaded, then re-check after the first few hard drives, since the spherical bearings remove the deflection that the stock rubber bushings used to hide.

All ISR Performance products are designed for off-road use only.