ISR Performance Driveshaft - S14 240SX KA/SR Non ABS - Steel

The ISR Performance steel driveshaft for non-ABS S14 240SX chassis replaces the factory driveshaft with a one piece, balanced unit built around the stock KA24DE or SR20DET drivetrain. It fits 1995 to 1998 cars without ABS, and the length and rear flange are set up for the differential those cars use.

Built to take a beating

Among the ISR driveshaft options, steel is the one that prioritizes strength and value. It is the durable, budget friendly choice that shrugs off the abuse of drift and track use, where a shaft sees sudden load reversals, hard shifts and the occasional off track excursion. The one piece layout also means there is no center support bearing to go soft and start vibrating, a common complaint on high mileage 240SX cars.

Features

• One piece steel driveshaft, dynamically balanced
• High quality universal joints
• Rear flange matched to the non-ABS S14 differential
• Bolts straight in with no modification when combined with the matching ISR swap mounts

Chassis and engine coverage

• 1995 to 1998 Nissan 240SX S14
• KA24DE or SR20DET, factory drivetrain
• Non-ABS cars only

Picking the right part number

The correct ISR driveshaft depends on engine, transmission, and ABS or non-ABS. Double check all three. If you are unsure, contact us before ordering and we will confirm fitment for your car.

All ISR Performance products are designed for off-road use only.