ISR Performance Driveshaft - S13 240SX KA/SR Non ABS - Aluminum

Cutting rotating mass is one of the cheapest ways to make a 240SX feel sharper, and the driveshaft is a large, heavy piece of that mass. This ISR Performance aluminum driveshaft for the S13 240SX is a one piece, balanced unit built for the factory KA24DE or SR20DET drivetrain, sized for non-ABS cars from 1989 to 1994 so the length and rear flange line up with the correct differential.

What the aluminum version gets you

Less mass spinning between the transmission and the rear end means the engine picks up revs faster and the drivetrain sees less shock load every time you get on and off the throttle. For a drift car that is constantly transitioning, or a track car that lives in the upper gears, that quicker response is noticeable from the driver's seat.

How it is built

• One piece aluminum shaft, no center carrier bearing to wear out
• Dynamically balanced for smooth running at speed
• High quality universal joints at the transmission and differential ends
• Direct bolt in, no modification, when used with the matching ISR swap mounts

Vehicle compatibility

• 1989 to 1994 Nissan 240SX (S13 chassis)
• KA24DE or SR20DET with the stock drivetrain
• Non-ABS cars only

Before you order

Three details determine which ISR driveshaft fits: engine, transmission, and ABS or non-ABS. Check all three against your car. Not sure? Reach out before ordering and we will verify the correct part for your setup.

All ISR Performance products are designed for off-road use only.