ISR Performance - Silicone Coupler - 3.00" 90 Degree - Black

Make a right-angle turn in 3 inch piping with the ISR Performance 3.00 inch 90 degree silicone coupler, finished in black. Larger intercooler and intake systems frequently need a tight 90 at the intercooler end tank, the throttle body, or the turbo inlet, and a silicone elbow handles that corner while also giving the pipe run some flexibility. The silicone construction tolerates engine bay heat and keeps the joint sealed under boost or inlet vacuum.

What you get

• 90 degree elbow coupler, 3.00 inch inside diameter
• Black silicone
• Equal-length legs for clamping on either side
• One elbow per order

Fitment

Universal part joining two 3.00 inch OD pipes at 90 degrees. Suits intercooler piping, intake tubes and turbo inlet plumbing on any chassis. Check the pipe outside diameter with calipers first.

Fitting notes

Clamp each leg with a 3 inch T-bolt clamp placed over the straight section of the leg. Because a 3 inch elbow carries a lot of force under boost, use beaded pipe ends and tighten evenly. If the elbow is used on the intake side, make sure it is not pulled into a kink that could restrict flow. Weight is around 1 lb.

All ISR Performance products are designed for off-road use only.